Orved evox 25 Manual De Uso página 41

7) Proceed to the preliminary clearing of vacuum chamber and lid. See chap.5.1
8) Final checks.
Carry out the following checks before switching the machine on:
• Check the correct electric connection.
• Check the pump oil.
When these checks have been completed:
• In order to calibrate the vacuum sensor to the atmospheric pressure level, at the first use and any time the machine
is moved from a place to another at a different altitude, it's necessary to operate the vacuum sensor calibration.
Connect the machine, then press the PUMP key for 5 seconds and close the lid. Wait until the end of the cycle.
• Check the absorption using an ammeter.
• Carry out at least one complete vacuum packing functioning cycle for bags.
• Inform the customer regarding the exact use of the machine with specific reference to use and the requirements of
the customer himself.
Rev. 02 - 05/2016 - Cod. 1500015 - Instruction manual for vacuum chamber packaging machines EVOX 25 / EVOX 25 H
INSTALLATION
41