Adjusting The Headrest Height - Baby auto UNIT fix 012 Manual De Uso

3. Take off the seat cushion to facilitate the installation.
4. Pass the abdominal strap of the seat belt through the lower
seat guides
you hear a click (fig. 3.4).
5. Pass the diagonal section of the seat belt through the
corresponding upper guide
6. Take up the remaining slack of the diagonal section of the 3-point
seat belt (fig. 3.6). and make sure it is as tight fitting as possible.
Ensure the straps are not twisted or knotted at any point.
7. Place the seat cushion on the seat.
4. PlacING THe cHIld IN THe seaT. GroUP 0+
Proper adjustment of the height of the harness ensures the
child will be seated correctly. The harness should be adjusted
to the height of the child's shoulder or slightly above; never
behind the child's back or level with the ears (fig. 4.1).
1. Loosen the harness straps
pressing the harness adjustment button
2. Release the buckle
4.3).
3. Place the child in the seat.
4. Secure the child in the harness by joining the two parts
of the clasp and fastening the buckle
click (fig. 4.4).
5. Gently pull the harness adjustment strap to achieve the
correct tension
ensure the child's safety the harnesses should fit tightly.

5. adJUsTING THe HeadresT HeIGHT

Proper adjustment of the height of the headrest ensures the
child will be seated correctly. The headrest should be adjusted
to ensure that the harness straps
height of the child's shoulder or slightly above; never behind
22
(K) (fig.3.3) and buckle the vehicle seat belt until
(F) to make it easier to seat the child (fig.
(G)
(fig. 4.5). Remember that in order to
(Q) as shown (fig. 3.6).
(e) by pulling them gently while
(F)
(e)
should be adjusted to the
(J) (fig. 4.2).
until you hear a