Baby auto UNIT fix 012 Manual De Uso página 23

the child's back or level with the ears (fig. 4.1).
1. Loosen the harness straps
pressing the harness adjustment button
2. Adjust the headrest according to the child´s height by pulling the
headrest height regulator
of the child´s shoulder or slightly above (fig. 5.2).
6. INsTallING THe car seaT. GroUP 1
notice
1. Ensure the seat is not in a reclined position (the indicator
should be in position 1) and is ready to install in forward
position (Group 1) as shown fig. 6.1. Pull the lever
and adjust the angle of recline to position 4 without releasing
the lever. Release the lever when the seat is in the desired
position (fig. 6.1)
2. Pull the iSoFiX adjuster
locking arms from side to side until you hear the click indicating
that they are fully locked (fig. 6.2).
3. Take the top tether and pass it over the seat.
4. Place the child safety seat in the back seat of the vehicle
facing in the direction of travel.
5. Hold the safety seat with both hands and insert the two locking
arms (M) into the verhicle´s isofix connectors until they fasten
with a click on both sides. The red button will change to green
on both sides (fig. 6.3).
6. Shake the seat to check that it is correctly anchored to the
vehicle's iSoFiX points.
IMPORTANT! The locking arms are only correctly fixed if both
safety buttons are green.
7. Pull the iSoFiX adjuster and push the safety seat towards the
back using a firm, constant pressure on both sides until it rests
(e)
by pulling them gently while
(a)
adjusting the harness to the height
GROUP 1 only. From 9 months to 4 years
approx. (9-18 kg)
(I) to extract both arms (M). Move the
(J) (fig. 5.1).
(H) forward
23