Stihl HT 102 Manual De Instrucciones página 17

HT 102, HT 132
Always hold the shaft with your left hand
in the area of the handle hose.
The shaft should always be held at an
angle of 60° or less.
The least tiring working position is a tool
angle of 60°.
Any lesser angle may be used to suit the
situation.
HT 102, HT 103, HT 132, HT 133
Cross-cut
To avoid pinching the bar in the cut,
position the cutting attachment with the
housing against the branch and then
perform the cross-cut from the top
downwards.
Relieving cut
2
1
To avoid tearing the bark on thick
branches, always start by performing a
relieving cut (1) on the underside of the
branch.
To do this, apply the cutting
N
attachment and pull it across the
bottom of the branch in an arc as far
as the bar nose.
Perform the cross cut (2) – position
N
the bar with the housing against the
branch.
Flush-cutting thick branches
A
4
If branch diameter is more than
10 cm (4 in), first
perform undercut (3) and then
N
cross-cut at a distance of about
20 cm/8 in (A) from the final cut.
Then carry out the flush-cut (4),
starting with a relieving cut and
finishing with a cross-cut.
English
3
15