Stihl HT 102 Manual De Instrucciones página 38

English
Checking the Spark Plug
Clean dirty spark plug.
N
Check electrode gap (A) and
N
readjust if necessary – see chapter
"Specifications."
Use only resistor type spark plugs of
N
the approved range.
Rectify problems which have caused
fouling of spark plug:
too much oil in fuel mix,
–
dirty air filter,
–
unfavorable running conditions, e.g.
–
operating at part load.
36
A
WARNING
To reduce the risk of fire and burn injury,
use only spark plugs authorized by
STIHL. Always press the spark plug
boot (1) snugly onto the spark plug
terminal (2).
Do not use a spark plug with a
detachable SAE adapter terminal (3).
Arcing may occur that could ignite
combustible fumes and cause a fire.
This can result in serious injuries or
damage to property.
Only use resistor type spark plugs
N
with solid, non-threaded terminals
Installing the Spark Plug
Screw the spark plug (3) into the
N
cylinder.
Tighten down the spark plug (3) with
N
the combination wrench.
1
3
2
Press the boot (2) firmly onto the
N
spark plug.
Fit the cover (1) and screw it down
N
firmly.
HT 102, HT 103, HT 132, HT 133