Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
C) TECHNICAL CHARACTERISTICS:
1) GENERAL:
- Channels
- Modulation modes
- Frequency ranges
- Antenna impedance
- Power supply
- Dimensions (in mm)
- Weight
- Accessories supplied
2) TRANSMISSION:
- Frequency allowance
- Carrier power
- Transmission interference
- Audio response
- Emitted power in the adj. channel : inferior to 20 µW
- Microphone sensitivity
- Drain
- Modulated signal distortion
3) RECEPTION:
- Maxi. sensitivity at 20 dB sinad
- Frequency response
- Adjacent channel selectivity
- Maximum audio power
- Squelch sensitivity
- Frequency image rejection rate
- Intermediate frequency rej. rate
- Drain
: 40
: AM/FM/USB/LSB
: from 26.965 MHz to 27.405 MHz
: 50 ohms
: 13.2 V
: 200 (L) x 260 (H) x 60 (D)
: 1.5 kg
: microphone with support, mounting
cradle, screws and fused power cord.
: +/- 100 Hz
: 1 W AM / 4 W FM / 4 W PEP SSB
: inferior to 4 nW (- 54 dBm)
: 300 Hz à 3 KHz in AM/FM/USB/LSB
: 1,0 mV
: 1,7 A (with modulation)
: 1,8 %
: 0.4 µV - 113 dBm (AM/FM)
0.2 µV - 121 dBm (USB/LSB)
: 300 Hz à 3 kHz in AM/FM/USB/LSB
: 60 dB
: 5 W
: minimum 0.2 µV - 120 dBm
maximum 1 mV - 47 dBm
: 60 dB
: 70 dB
: 500 mA nominal
(without
800 mA maximum
LF signal)
800 mA nominal
(with LF signal)
1.3 A
D) TROUBLE SHOOTING:
1) YOUR CB RADIO WILL NOT TRANSMIT OR YOUR TRANSMIS-
SION IS OF POOR QUALITY:
- Check that the antenna is correctly connected and that the SWR is properly
adjusted.
- Check that the microphone is properly plugged in.
2) YOUR CB RADIO WILL NOT RECEIVE OR RECEPTION IS POOR:
- Check that the squelch level is properly adjusted.
- Check that the volume is set to a comfortable listening level.
- Check that the microphone is properly plugged in.
- Check that the antenna is correctly connected and that the SWR is properly
adjusted.
- Check that you are using the same modulation mode as your correspondent.
3) YOUR CB WILL NOT LIGHT UP:
- Check the power supply.
- Check the connection wiring.
- Check the fuse.
E) HOW TO TRANSMIT OR RECEIVE A MESSAGE:
Now that you have read the manual, make sure that your CB Radio is ready
for use (i.e. check that your antenna is connected).
Choose your channel (19, 27).
Choose your mode (AM/FM) which must be the same as that of your
correspondent.
Press the «push-to-talk» switch and announce your message «Attention
stations, transmission testing» which will allow you to check the clearness and
the power of your signal. Release the switch and wait for a reply. You should
receive a reply like, «Strong and clear».
If you use a calling channel (19, 27) and you have established communica-
tion with someone, it is common practice to choose another available
channel so as not to block the calling channel.
29
Publicidad
Tabla de contenido
