10) PTT (push to talk)
Depress the PTT (10) pedal to transmit a message and release to listen to an incoming
communication.
TOT (Time Out Timer)
If the PTT key (10) is pressed for more than 5 minutes, the transmission ends until the
PTT key (10) is released.
A) DC-POWER TERMINAL (13,2 V)
B) ANTENNA CONNECTOR (SO-239)
C) EXTERNAL SPEAKER JACK (8 Ω, Ø 3,5 mm)
C) TECHNICAL CHARACTERISTICS
1) GENERAL
- Channels
- Modulation modes
- Frequency ranges
- Antenna impedance
- Power supply
- Dimensions (in mm)
- Weight
- Accessories supplied
- Filter
: 40
: AM/FM
: from 26.965 MHz to 27.405 MHz
: 50 ohms
: 13.2 V
: 115 (L) x 180 (H) x 35 (D)
: 0,8 kg
: Electret microphone with support, mounting
cradle, screws.
: ANL (Automatic Noise Limiter) built-in
2) TRANSMISSION
- Frequency allowance
- Carrier power
- Transmission interference
- Audio response
- Emitted power in the adj. channel : inferior to 20 µW
- Microphone sensitivity
- Drain
- Modulated signal distortion
3) RECEPTION
- Maxi. sensitivity at 20 dB sinad
- Frequency response
- Adjacent channel selectivity
- Maximum audio power
- Squelch sensitivity
- Frequency image rejection rate
- Intermediate frequency rej. rate
- Drain
D) TROUBLE SHOOTING
1) YOUR CB RADIO WILL NOT TRANSMIT OR YOUR TRANSMISSION
IS OF POOR QUALITY
-
Check that the antenna is correctly connected and that the SWR is properly adjusted.
-
Check that the microphone is properly plugged in.
-
Check that the programmed configuration is the correct one (see table page 49).
30
: +/- 300 Hz
: 4 W AM / 4 W FM
: inferior to 4 nW (- 54 dBm)
: 300 Hz to 3 KHz in AM/FM
: 10 mV
: 1,7 A (with modulation)
: 1,8 %
: 0.5 µV - 113 dBm (AM/FM)
: 300 Hz to 3 kHz in AM/FM
: 60 dB
: 5 W
: minimum 0.2 µV - 120 dBm
maximum 1 mV - 47 dBm
: 60 dB
: 70 dB
: 500 mA nominal / 800 mA maximum