Enabling And Disabling Auto Impedance - Boston Scientific Vercise DBS Instrucciones De Uso

Enabling and Disabling Auto Impedance

The Auto Impedance feature automatically measures the impedances of the Vercise™ DBS
System when you enter the Programming screen. The Auto Impedance feature will be disabled
whenever the Bionic Navigator software is exited.
If the Auto Impedance feature is disabled, the contacts on the Programming screen will display an
[X] until you measure impedances. If the Auto Impedance feature is enabled, no [X]'s will appear on
the Programming screen (unless impedances are over 4500 Ω for a specific contact).
To enable the Auto Impedance feature:
1 Click from the toolbar on any screen.
2
Select Enable Auto Impedance from the drop-down menu.
To disable the Auto Impedance feature:
1
Click from the toolbar on any screen.
2
Select Disable Auto Impedance from the drop-down menu.
Using Additional Tools
Vercise™ DBS Programming Manual
91053785-07 65 of 323