Setting Up; Connecting The Remote Control To The Clinician Programmer - Boston Scientific Vercise DBS Instrucciones De Uso

Vercise™ DBS Programming Manual

Setting Up

Connecting the Remote Control to the Clinician Programmer

The Clinician Programmer communicates with the Stimulator via the Remote Control. The Clinician
Programmer is connected to the Remote Control using an infrared (IR) link. The Remote Control
uses a radio frequency (RF) link to communicate with the Stimulator. Programs can be loaded
to the Clinician Programmer for previewing, activating, and changing stimulation parameters.
Stimulation programs can also be saved to the Remote Control.
CAUTION: Use only Vercise™ DBS System components with the Clinician Programmer.
Failure to do so can result in inappropriate stimulation.
CAUTION: The CP is not equipment for the patient environment as defined by IEC 60601-1.
The CP and the person using the CP should not be in contact with the patient
while programming.
To connect the remote Control to the Clinician Programmer:
1 Plug the USB to Serial Cable into any USB port on the Clinician Programmer.
2 Plug the serial end of the USB to Serial Cable into the matching end of the IR Interface.
3 Insert the IR Interface and Remote Control into the plastic holder to keep the IR windows
aligned, as shown below.
1
Vercise™ DBS Programming Manual
91053785-07 2 of 323
2 3