Safety Instructions - Medela Vario Instrucciones De Uso

Safety instructions

– The Medela Vario is a medical device that requires special safety measures in regard to eMC.
It must be installed and put into operation in accordance with the attached eMC information.
– In the case of overflow, inform the internal technical service immediately and perform the tasks
in the service manual.
– In each of the following cases, the device must not be used and it must be repaired by
Customer Services:
– if the power cord or the plug are damaged
– if the device is not functioning perfectly
– if the device is damaged
– if the device shows clear safety defects.
– Keep the power supply cord away from hot surfaces.
– The mains plug and the on / off switch must not come into contact with moisture.
– Never pull the mains plug out of the fixed mains socket by pulling on the power supply cord!
– Never leave the device unattended when it is switched on.
– The pump must stand upright during use.
– Never place the power supply cord around your neck.
– Never use the device at high room temperatures, while bathing or showering, if you are very
tired or in an environment where there is a risk of explosion.
– Never place the device in water or other liquids.
– When using single use, sterile products, please note that they are not intended to be
reprocessed. reprocessing could cause loss of mechanical, chemical and / or biological
characteristics. reuse could cause cross contamination.
– Contact your local Medela customer service representative for assistance with product
operations.
– Do not place a 2 l suction jar in the lateral adaptor.
– The overflow protection / bacteria filter protects the pump against overflow. Caution: Suctioning
is interrupted when the filter is wet / moist or clogged. Test the filter before each use and
during use periodically (see chapter 17).
These instructions for use must be kept for later reference.
Warnings and safety instructions
| 7