Lincar Mya 505 Manual Del Usuario página 55

MENU 02 (set clock)
With this Menu you can adjust the time and the date of the electronic card, the set date and
time will be utilized as reference for the activation of the switch ON/OFF programs
Pay ATTENTION to the regulation of the Time and Date, these regulations will influence the
on/off programs for the automatic lighting and turning off.
MENU 03 (set chrono)
Within this Menu you can set up the automatic cycles of switching ON/OFF you desire to
utilize. There are 3 different modalities you can use even contemporaneously, but pay
attention to not overlap the programs.
PROGRAM DAY. The programs inserted in this section will be repeated every day of the
week in the same way (max 2 ON/OFF cycles)
PROGRAM WEEK. With the programs inserted in this section you can effect different
ON/OFF during the days of the week (max 4 ON/OFF cycles
PROGRAM WEEK-END. The programs inserted in this section will be repeated
exclusively on Saturday and Sunday (max 2 ON/OFF cycles).
MENU 04 (language)
Within this Menu you can change the language utilized by the control panel. There are 4
possibilities: Italian – English – German - French
MENU 05 (select feeler)
Within this Menu you can select in which way you want to take the room temperature. It is
possible to take the temperature by mean of the feeler put on the back of the appliance or by
mean of the feeler put on the radiocontrol. If you intend to use the feeler on the radiocontrol,
we suggest to fix the support of the radiocontrol in the coolest place of the room.
Alternatively on the lh side of the appliance the are 2 holes for the fixing of the support.
MENU 06 ( stand-by)
The appliance is preset to work in 2 (two) different modalities
1 st Modality, -STAND-BY OFF- as preset by the factory.
Once the appliance has reached the selected temperature, the modulation starts and it put
itself to power 1 in order to reduce the fuel consumption. When the temperature goes under
the selected value the equipment restore the functioning on setting power. i.e. pow.3)
2 Modality, -STAND-BY ON-.
nd
Once the appliance has reached the selected temperature, the modulation starts, and it put
itself to power 1 in order to reduce the fuel consumption. In case that even at power 1 the
temperature continue to raise, the appliance starts the switch off cycle and the display will
signal " ECO-STOP STAND BY".
MENU 07 (BEEP SOUND)
Within this Menu you can select the modality BEEP (buzzer).
OFF, no sound ON, sound in case of alarm.
MENU 08 (INITIAL LOADING)
With this Menu you can set the continuous fuel load, this operation can only be effected
when the display is evidencing "OFF". This menu is utilized to fill the screw feeder when the
appliance is new or in case of emptying of the pellet container.
MENU 09 (STOVE STATUS)
In this Menu you can find some informations about the working of the (info for technical
staff).
55/128
IT-GB-FR-ES mod. 505