Lincar Mya 505 Manual Del Usuario página 64

No fire is noted
Error
in the burner
Fire
basket
Fume exhaust
Failure
duct clogged
Depress
Pellet
temperature too
high
Safety
Thermal
(See automatic
safety
features)
Exhaust feeler
Feeler
signaling error
Exhaust
Fume
Hot
temperature too
Exhaust
high
A black-out has
happened
Black-Out during the
regular
working.
Triac Co
Error Card Triac
Every intervention has be done from qualify staff !
Disconnect the equipment from electrical system before every maintenance operation
Every repairs must be done by our authorized assistance centre.
CORISIT S.r.l. is not responsible for damages to thing or people due to a wrong installation,
equipment tampering, improper use, bad maintenance or no observation of normative in
force. If considerate appropriate, CORISIT S.r.l. reserves the right to make modifications
without notice and in every moment.
Some particulars and accessories illustrated in this handbook are not mass produced item so
its extra costs are to check at contract release.
No pellet feeding
Fume feeler
Chimney clogged.
Electrical connections
interrpted.
Breakdown pressure switch
Up and frontal exhaust air
tank
are obstructed
Temperature thermostat is
broken
Convection motor is
broken
Wrong appliance
carburation.
Change fuel.
Fume feeler
-----------------
-----------------
64/128
IT-GB-FR-ES mod. 505
Verify pellet available in container
Verify screw feeder operating
Verify stoppage/clogging screw
feeder.
Verify electrical wire.
Verify the position of fume feeler.
Verify/replace fume feeler.
Verify chimney.
Verify integrity electrical connections
of pressure switch.
Replace pressure switch
Checking the up and frontal exhaust
air
To substitute thermostat
Checking the convection motor
Verify/replace exhaust feeler.
Verification of appliance by a
technical service center.
Proceed with "Pellet Correct".
Verification of appliance by a
technical service center.
Utilize better quality of pellet .
Proceed with "Pellet Correct".
Verify fume feeler position.
Verify/replace fume feeler.
Empty and clean the burner basket
and then proceed with the lighting
phase.
Call for technical service
.