Tecno-gaz alia B Instrucciones De Uso página 76

ENGLISH
1 – Install the autoclave in environments suitable to sterilization.
2 – The premises have to be suitably lit and ventilated, in compliance with regulations in
force.
3 – Install the autoclave away from heat sources and water splashes.
4 – Position the autoclave on a plane suitable to bear its weight (min.80 kg) and of suitable
dimensions.
5 – The surface supporting the autoclave must be perfectly horizontal.
6 – Place the autoclave at a height allowing easy intervention by the operator for
inspection and clearing of the whole sterilization chamber.
7 – Open the door of the autoclave and remove all packages containing the single
accessories from inside the sterilization chamber.
8 – Leave inside the sterilization chamber only the tray carrier with the trays. All other
accessories should be positioned in a separate space available to operators.
9 – Never place on the autoclave newspapers, trays, liquid containers, etc...
10 – Do not lean on the door when it is open.
11 – Leave a space of at least 5 cm in the rear of the autoclave, using the spacer (FIG.1–
pos.8 / FIG.17) and in the sides of the unit to ensure the ventilation required.
12 – Connect the overflow discharge hoses in the rear panel (FIG.1–pos.1-3). Water can
be discharged either in a tank or directly into the tub discharge.
13 – Always make sure the electrical system to which the autoclave is to be connected is
in conformity with the legislation in force and sized to suit the specifications of the said
device.
14 – Connect the power supply cord to the socket on the rear panel of the autoclave
(FIG.1–pos.5)
15 – Connect the power plug to the system and make sure the power supply is 230 Vac-
2000Va
IMPORTANT:
Do not use extensions, reducers or adapters for connection as this could cause
micro interruptions with consequent generation of alarm signals.
20