Motor Run-Down Brake; Operating The Machine; Switching On The Lawn Mower; Switching Off Lawn Mower - Viking ME 443 Manual De Instrucciones

10.1 Safety devices
The lawn mower is equipped with safety
devices, which prevent inadvertent contact
with the mowing blade and with ejected
clippings.
These include the housing, discharge flap,
grass catcher box and correctly installed
handlebar.
10.2 Two-hand operation
The motor can only be switched on by
pressing and holding the ON button with
the right hand and then pulling the
motorstop lever to the handlebar with the
left hand.

10.3 Motor run-down brake

When the motorstop lever is released, the
mowing blade comes to a complete
standstill in less than three seconds.
An integrated motor run-down brake
shortens the run-down time until the blade
stops.

11. Operating the machine

11.1 Electrical connection
Danger of electric shock!
Observe the safety instructions in
the section "For your safety" (
If using a cable drum, the
connection cord must be unwound
completely, otherwise electrical
resistance may cause loss of power
and overheating.
40
Only electric cables which are no lighter
than rubber sheathed cables H07 RN-
F DIN/VDE 0282 may be used as electric
cables.
Recommended minimum cross-
section:
up to 25 m Length: 3 x 1.5 mm²
up to 50 m Length: 3 x 2.5 mm²
The connectors of the electric cable must
be made of rubber or have a rubber cover
and conform to the standard
DIN/VDE 0620.
The mains voltage and mains frequency
must correspond to the information on the
identification plate and the information
contained in the section
"Technical specifications" (
The power cable must be adequately
protected by a fuse (
This machine is intended for operation with
a power supply having a system
impedance of Z
max
(house connection) of maximum
0.49 ohms (at 50 Hz).
The user must ensure that the machine is
only operated with a power supply which
meets this requirement. If necessary, this
information can be obtained from the local
electric power company.
11.2 Strain relief
During working, the strain relief
prevents any unintentional
disconnection of the electric cable and any
4.).
resulting damage to the mains connection
on the machine.
For this reason, the electric cable must be
fed through the strain relief.
18.).
18.).
at the transfer point
11
● Form a loop in the power cable (1) and
guide it through the opening (2).
● Then push the loop over the hook (3)
and pull it tight.
11.3 Switching on the lawn
mower
Do not start the motor in high grass
or when the mower is set to the
lowest cutting height, as this makes
switching on difficult.
● Press and hold down the ON button (1).
Pull motorstop lever (2) to handlebar
and hold.
● The ON button (1) can be released
once motorstop lever (2) is pressed.

11.4 Switching off lawn mower

● Release motorstop lever (1).
Motor and mowing blade come to
a stop after a short run-down time.
11.5 Emptying the grass catcher
box
Risk of injury!
The motor must be stopped for
safety reasons before removing the
grass catcher box.
● Detach the grass catcher box. (
● Open the grass catcher box at the
tab (1). Fold up the upper part of the
grass catcher box (2) and hold. Fold the
grass catcher box rearwards and empty
the clippings.
● Close the grass catcher box.
0478 121 9920 D - EN
12
13
14
8.3)