Sawing With The Adaptation Table - Festool CARVEX PS 420 EBQ Manual De Instrucciones

 For 90° cuts, we recommend setting the angle
table to a small negative angle to guarantee
smooth operation.
8
16
8-2

Sawing with the adaptation table

The adaptation table ADT-PS 400 is used for attach-
ing your jigsaw to the Festool guide rail, the circle
cutter KS-PS 400 and the CMS modular system.
With guide rail and circle cutter: do not ex-
ceed max. material thickness of 20 mm and
always use cross-set saw blades (FSG).
Installing the adaptation table

Remove the saw table [1-11], (see chapter-
Changing saw table).

Mount the adaptation table [9-1] on the saw ta-
ble support.
8-1

Close the change lever [1-9].
Ensure that the adaptation table is firmly seated in
the guide.
 Use the extractor connector [1-8] also with the
adaptation table.
9
Adaptation to the guide rail FS 2
The Festool guide system FS 2 (Fig. [10]) makes it
much easier to manufacture straight precision
cuts.

Place the jigsaw with attached adaptation table
[9-1] on the guide rail.
ADT-PS 400
9-1
Attention: Only use with
materials thinner than
20mm and cross-set sawblade!