Working With The Machine - Festool CARVEX PS 420 EBQ Manual De Instrucciones

saw table) before inserting the saw blade.
Adjust the saw blade guide after every saw blade
change:
The saw blade guide was designed to improve guid-
ance of the saw blade.

Remove the saw base (see chapter Changing
saw table).

Tighten the screw [6-2] using the Allen key [6-
1] until the jaws are almost touching the saw
blade.
NOTE
Damage to the machine or saw blade

Do not tighten the screw [6-2] too firmly! It must
be possible to move the saw blade slightly.
CAUTION
Material with high dust generation (e.g. plaster-
board)
Damage to machine through dust penetration,
risk of injury

Do not work overhead!
6
Ejecting saw blade
 When ejecting the saw blade, hold the electric
power tool such that no persons or animals can
be injured.

Push the saw blade ejection [5-3] forwards as
far as the stop.
 A tool change is only possible when the tool
holder is located in the upper position!
If the saw blade is stuck and cannot be changed:
Operate the jigsaw at high speed for 3 - 10 seconds.
Actuate the saw blade ejection [5-3]again.

Working with the machine

Risk of injury

With the tool switched off and unplugged, check
for tight fit of the sawblade before starting to
work

Always apply the pendulum jigsaw to the work-
piece with the sawblade running.

Wait until the power tool stops completely until
placing it down. The tool can become entangled
and lead to a loss of control of the power tool.
When working on small or thin workpieces, always
use a stable base.
When working, hold the electric power tool by the
handle and guide it along the desired cutting line.
+
-
WARNING
6-1
6-2
13