√ Micro-Kill+™ (Micro-Kill Plus™) by Medline (EPA Reg. No. 59894-10-
37549)
To obtain disinfecting wipes and other information, please contact
Medline at 1-800-MEDLINE (1-800-633-5463) or visit www.medline.
com. You can also purchase at www.amazon.com.
Disinfecting Procedures
1. Take out one disinfecting wipe from the package and squeeze out
any excess liquid in order to prevent damage to the meter.
2. Wipe all meter's exterior surface display and buttons. Hold the
meter with the test strip slot pointing down and wipe the area around
the test slot but be careful not to allow excess liquid to get inside.
Keep meter wet with disinfection solution contained in the wipe for a
minimum of 2 minutes for Micro-Kill+™ wipes. Follow the instructions
on the package label of disinfecting wipe.
3. Remove the wipe. Allow the meter surface to dry completely.
4. Discard the used wipes and never reuse them. Wash your hands
thoroughly with soap and water after handling the meter, lancing
device and test strips to avoid contamination.
Each cleaning and disinfection cycle includes a pre-cleaning step with
one wipe and a disinfection step with a second wipe.
42