Cleaning The Feed Dogs; Oiling The Machine - Janome QS2250 Manual De Instrucciones

q
w
e
Cleaning the Feed Dog
Note:
Turn off the power switch or unplug the
machine before cleaning the feed dog.
Remove the needle and the presser foot.
Remove the needle plate set screw and remove
the needle plate.
With a brush, clean out dust and lint clogging the feed
dog teeth.
Reset the needle plate.

Oiling the Machine

Oil the points as shown at least once a year.
Use good quality sewing machine oil.
One or two drops of oil is sufficient.
Remove excess oil, otherwise it may stain fabric.
If machine has not been used for an extended time,
oil it before sewing.
Oil behind the face plate
Remove the cap, screw and face plate.
Oil the point indicated in the illustration.
q
Cap
w
Screw
e
Face plate
Oiling the shuttle hook area
Open the hook cover by pulling down the embossed part
on the left side of the cover.
Oil the point indicated in the illustration.
r
Hook cover
r
66