Bosch eShift Shimano Nexus Di2 Instrucciones De Servicio página 19

eShift with the Nyon On-board Computer
(BUI350)
The gear or switching mode (manual M/automatic A) is al-
ways displayed on the <Ride Screen> and in any displays
that can be freely configured by the user (see on-board com-
puter operating instructions). If another screen is active, the
gear and the switching mode will be briefly shown each time
the gear is changed.
The drive unit detects the gear shift and briefly reduces the
motor assistance level as a result, which means the gear can
also be shifted at any time under load or on a hill.
If the eBike is brought to a stop from a speed of more than
10 km/h, the system may automatically shift down a gear to
a set starting gear.
Bosch eBike Systems
The starting gear can be set under <Settings> → <My
eBike> → <eShift> → <Start Gear>. To do this, first set the
slider to active. The gears that can be selected will then ap-
pear below the slider. On the display, tap on the required
starting gear. A tick indicates that the gear is selected.
You can carry out fine adjustment of the Shimano Di2 under
<Adjust Gear>. The set value is immediately adopted if you
press the + or – button on the operating unit.
The pre-defined setting range can be found in the operating
instructions provided by the gearing manufacturer. Perform
fine adjustment as soon as you hear the gearing make un-
usual noises.
English – 5
0 275 007 XES | (17.04.2020)