Bosch eShift Shimano Nexus Di2 Instrucciones De Servicio página 23

eShift with the Kiox on-board computer
With the NuVinci/enviolo gear shifting, the desired cadence
can be changed while riding using the operating unit.
To do this, press the select button and use the right-hand
button to navigate to the <Cadence> option. Then adjust the
value using the + or – button on the operating unit. Next time
you open the <Settings> menu, the <Cadence> option will
immediately be displayed, as the last setting on your on-
eShift with the Nyon On-board Computer
(BUI350)
With the NuVinci/enviolo gear shifting, you can change the
required cadence while riding using the operating unit and
the <Quick Menu>. To do this, press the select button and
use the right-hand button to navigate to the <Cadence> op-
tion. Then adjust the value using the + or – button on the op-
erating unit.
Next time you open the <Quick Menu> menu, the
<Cadence> option will immediately be displayed, as the last
setting on your on-board computer will have been saved.
Bosch eBike Systems
board computer will have been saved. Kiox does not support
a manual switching mode.
Under <Calibration>, you can calibrate the continuously
variable transmission. Then follow the instructions on the
display.
In the event of an error, it may also be necessary to perform
calibration when riding. Confirm the calibration here too,
and follow the instructions on the display.
The current cadence and the maximum cadence in rpm is al-
ways shown on the <Ride Screen> and in any displays that
can be freely configured by the user (see on-board computer
operating instructions).
Nyon does not support "Manual switching" mode. You can
calibrate the continuously variable transmission under <Set-
tings> → <My eBike> → <eShift> → <Calibration>. Follow
the directions on the display.
In the event of an error, it may also be necessary to perform
calibration when riding. Confirm the calibration here too,
and follow the instructions on the display.
English – 9
0 275 007 XES | (17.04.2020)