Bosch eShift Shimano Nexus Di2 Instrucciones De Servicio página 21

eShift with the Kiox on-board computer
The gear and switching mode (manual M/automatic A) are
always displayed on the start page. If you are on another
screen, the gear will be briefly shown on the display each
time it is changed.
The drive unit detects the gear shift and briefly reduces the
motor assistance level as a result, which means the gear can
also be shifted at any time under load or on a hill.
You can carry out fine adjustment of the Shimano Di2 under
<Adjust gear>. The pre-defined setting range can be found
in the operating instructions provided by the gearing manu-
eShift with the Nyon On-board Computer
(BUI350)
The gear or switching mode (manual M) is always displayed
on the <Ride Screen> and in any displays that can be freely
configured by the user (see on-board computer operating in-
structions). If another screen is active, the gear and the
switching mode will be briefly shown each time the gear is
changed.
The drive unit detects the gear shift and briefly reduces the
motor assistance level as a result, which means the gear can
also be shifted at any time under load or on a hill.
You can carry out fine adjustment of the Shimano Di2 under
<Settings> → <My eBike> → <eShift> → <Adjust Gear>.
Bosch eBike Systems
facturer. Perform fine adjustment as soon as you hear the
gearing make unusual noises.
Press the operating unit select button in the menu and then
select the <My eBike> menu item using <Settings> +/–.
Under this item, you will find the <eShift> menu item with
the sub-item <Adjust gear>.
<Reset> : You can use this menu item to reset the gearing if
it has been moved out of position, e.g. after a knock to the
gearing or a fall. The procedure for resetting the gearing is
described in the operating instructions from the gearing
manufacturer. This menu item is displayed only when the on-
board computer is in the holder.
The set value is immediately adopted if you press the + or –
button on the operating unit.
The pre-defined setting range can be found in the operating
instructions provided by the gearing manufacturer. Perform
fine adjustment as soon as you hear the gearing make un-
usual noises.
<Reset> : You can use this menu item to reset the gearing if
it has been moved out of position, e.g. after a knock to the
gearing or a fall. The procedure for resetting the gearing is
described in the operating instructions from the gearing
manufacturer. This menu item is displayed only when the on-
board computer is in the holder.
English – 7
0 275 007 XES | (17.04.2020)