Playing Back Discs; Playing Back The Entire Disc-Normal Play - JVC UX-J60 Manual De Instrucciones

Playing Back Discs

This unit has been designed to play back the following discs
—CD, CD-R, and CD-RW.
When playing a CD-R or CD-RW
User-edited CD-Rs (CD-Recordable) and CD-RWs
(CD-ReWritable) can be played only if they are already
"finalized."
• Usually you can play back your original CD-Rs or CD-
RWs recorded in music CD format. However, sometimes
they may not play depending on their characteristics or
recording conditions.
• Before playing CD-Rs or CD-RWs, read their instructions
or cautions carefully.
• Some CD-Rs or CD-RWs may not play on this unit because
of their disc characteristics, damage or stain on them, or if
the player's lens is dirty.
• CD-RWs may require a longer readout time. This is
because the reflectance of CD-RWs is lower than for
regular discs.
General notes
In general, you will have the best performance by keeping
your discs and the mechanism clean.
• Store discs in their cases, and keep them in cabinets or on
shelves.
• Keep the unit's disc tray closed when not in use.
Continued use of irregular shape discs
(heart-shape, octagonal, etc.) can damage the unit.
Handling discs
• Remove the disc from its case by
holding it at the edge while pressing the
center hole lightly.
• Do not touch the shiny surface of the
disc, or bend the disc.
• Put the disc back in its case after use to
prevent warping.
• Be careful not to scratch the surface
of the disc when placing it back in its
case.
• Avoid exposure to direct sunlight,
temperature extremes, and moisture.
To clean the disc
Wipe the disc with a soft cloth in a
straight line from center to edge.
DO NOT use any solvent—such as conventional record
cleaner, spray, thinner, or benzine—to clean the disc.
Playing Back the Entire Disc—Normal Play
1
Press CD 0.
The unit automatically turns on and the disc
tray comes out.
2
Place a disc correctly on the circle of the
disc tray, with its label side up.
CORRECT
• When using a CD single (8 cm), place it on the inner
circle of the disc tray.
3
Press CD 3/8.
The disc tray automatically closes and the first
track of the disc starts playing.
Track number Elapsed playing time
• The disc automatically stops when the last track has
finished playing.
To stop playing, press 7.
Total track number Total playing time
To remove the disc, press CD 0.
• If the disc cannot be read correctly (because it is scratched,
for example) or an unreadable CD-R or CD-RW is inserted
Playback will not start.
• If no disc is inserted
"NO DISC" appears on the display.
• If the loaded disc has more than 21 tracks and you select 21st
track or above
"– –:– –" appears on the display instead of the playing time.
DO NOT try to open or close the disc tray by hand
as it will be damaged.
Continued
CD
INCORRECT
CD
BASS
14