Optional Accessories; Applications; Preparation Before Operation - Hitachi C 8FB2 Manual De Instrucciones E Instrucciones De Seguridad

English

OPTIONAL ACCESSORIES

q Extension Holder and Stopper (Fig. 1) (Code No. 998866)
w Guard Assembly (A) (Adjustable) (Code No. 998984)
e Saw blade 8-1/2" (216mm) TCT Saw blade (Total teeth: 36) (Code No. 998860)
r Saw blade 8-1/2" (216mm) TCT Saw blade (Total teeth:60) (Code No.998862)
t Saw blade 8-1/2" (216mm) TCT Saw Blade for aluminum (Total teeth: 60) (Code No.998864)
NOTE:
Accessories are subject to change without any obligation on the part of the HITACHI.

APPLICATIONS

Wood and aluminum sash.

PREPARATION BEFORE OPERATION

Make the following preparations before operating the power tool:
1. Installation
5-29/32" (150mm)
11/32" (9mm)
3 Holes
Attach the power tool to a level, horizontal work bench in accordance with Fig. 4.
Select 5/16" (8mm) diameter bolts suitable in length for the thickness of the work bench.
Bolt length should be at least 1" (25mm) plus the thickness of the work bench.
For example, use 2" (50mm) or larger bolts for a 1" (25mm) thick work bench.
The holder attached to the rear of the base helps stabilize the power tool.
Base Holder
Adjust the base holder until
its bottom surface contacts
the work bench surface.
10
...sold separately
11-13/16" (300mm)
Base holder adjustment:
Loosen the 6mm bolt with the supplied 10mm box wrench.
Adjust the base holder until its bottom surface contacts the work
bench surface.
After adjustment, firmly tighten the 6mm bolt.
6mm Bolt
Move
Fig. 5
Base 5/16" (8mm) Bolt
Work Bench
Fig. 4
5/16" (8mm) Nut