Adjusting The End Limits - SOMFY Sunea io Guia De Instalacion

5.4. Adjusting the end limits

The end limits are set differently depending on type of awnings.
5.4.1. Setting for cassette awning
For cassette awning, the upper end limit is set automatically, while the lower end limit must be set.
Setting the lower end limit
Do not use the "my" and Down buttons at the same time to reach the lower end limit.
1) Set the awning to the lower end limit.
Press and hold the Down button for > 2 seconds to
lower the awning in one continuous movement.
2) Stop the awning in the desired position.
3) If necessary, adjust the position of the awning using the
Up or Down buttons.
4) Press the "my" and Up buttons simultaneously: the
awning is raised in one continuous movement even after
the "my" and Up buttons have been released.
5) At the halfway point, briefly press the "my" button to stop
the awning.
6) Press the "my" button again until the awning makes a
movement: the end limits have been programmed, go
to chapter "Programming the first Somfy io local control
point".
5.4.2. Settings for non-cassette awnings
For non-cassette awnings, the upper and lower end limits must be set.
Setting the upper end limit
1) Set the awning to the upper end limit.
Press and hold the Up button for > 2 seconds to raise
the awning in one continuous movement.
2) Stop the awning in the desired position.
3) If necessary, adjust the position of the awning using the
Up or Down buttons.
4) Press the "my" and Down buttons simultaneously: the
awning is lowered in one continuous movement even
after the "my" and Down buttons have been released.
5) At the halfway point, briefly press the "my" button to stop
the awning and go to the following step.
Setting the lower end limit
1) Set the awning to the lower end limit.
Press and hold the Down button for > 2 seconds to
lower the awning in one continuous movement.
2) Stop the awning in the desired position.
3) If necessary, adjust the position of the awning using the
Up or Down buttons.
4) Press the "my" and Up buttons simultaneously: the
awning is raised in one continuous movement even after
the "my" and Up buttons have been released.
5) At the halfway point, briefly press the "my" button to stop
the awning.
6) Press the "my" button again until the awning makes a
movement: the end limits have been programmed. Go
to chapter "Programming the first Somfy io local control
point".
Copyright © 2010 Somfy SAS. All rights reserved.
1 2
3 4
5 6
1 2
3 4
5
Go to the following
1 2
3 4
5 6
Sunea io
step
5