Motor/Tube Assembly; Fitting The Tube-Motor Assembly; Wiring - SOMFY Sunea io Guia De Instalacion

3.3. Motor/tube assembly

1) Slide the motor into the roller tube. For smooth roller
tubes, position the cut notch on the crown.
2) For safety reason, fix the roller tube to the drive wheel
with 4 self-tapping screws with a diameter of 5 mm or 4
steel pop rivets with a diameter of 4.8 mm located:
- at least 5 mm from the far end of the drive wheel:
L1 - 5, and
- no more than 15 mm from the far end of the drive
wheel: L1 - 15.
The screws or pop rivets must only be attached to the
drive wheel and not to the motor.

3.4. Fitting the tube-motor assembly

1) Fit the tube/motor assembly to the end bracket (C).
2) Fit the tube/motor assembly to the motor bracket (D).
3) Depending on the type of supports fit the stop ring (E) [For
the motors >= 85 Nm absolutely use the locking stop ring
(F)].

4. WIRING

Always make a loop in the power supply cable to prevent
water entering the motor!
- Cut the power supply off.
- Connect the motor according to the information in the
table below:
230 V ~ 50 Hz
1 Brown Live (P)
2 Blue Neutral (N)
3 Yellow/Green Earth ( )
Copyright © 2010 Somfy SAS. All rights reserved.
Motor cable
1
2 15 mm
L1
1
2
D
3
E
OFF
3 x 0,75 mm
1
230 V
2
~
3
50 Hz
3 x 1,5 mm 2
1
2
3
Sunea io
5 mm
20 mm
C
F
2
3