Programming The First Somfy Io Local Control Point; Checking The Settings; Use; Standard Operation - SOMFY Sunea io Guia De Instalacion

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Sunea io
5.5. Programming the first Somfy io local control point
5.5.1. Using the pre-programmed Somfy io local control point
-
Briefly press the PROG button on this control point (G):
the awning makes a brief movement, and the control
point has been programmed.
5.5.2. After a single power outage
1)
Press the Up and Down buttons simultaneously
this new control point (H) until the awning makes a
movement.
2)
Briefly press the PROG button on this control point (H):
the awning makes a brief movement, and the control
point has been programmed.

5.6. Checking the settings

-
Check the setting of the upper and lower end limits using the Somfy io local control point.

6. USE

6.1. Standard operation

6.1.1. Favourite position (my)
Definition
Besides the upper and lower positions, an intermediate position known as the "favourite position (my)"
may be programmed in the motor.
To program, modify or delete the favourite position (my), see the chapter "Additional settings"
section.
Using the favorite position (my):
-
Briefly press the "my" button: the awning starts moving
and stops in the favourite position (my).
6.1.2. STOP function
The awning is moving.
-
Briefly press the "my" button: the awning stops
automatically..
6.1.3. Up and Down buttons
Briefly press the Up or Down button to raise or lower the awning completely.
for the cassette awnings, the obstacle detection is active throughout the descent.

6.2. Operation with an Somfy io sensor

6.2.1. Operation with an Somfy io sun sensor (type Sunis WireFree™ io)
Refer to the corresponding guide.
6.2.2. Operation with an Somfy io wind sensor (type Eolis WireFree™ io)
Refer to the Somfy io wind sensor guide for details of its operation.
Awning's behaviour when the wind rising
When the wind rising, the awning moves to the upper
end limit. It is impossible to prevent awning from being
raised and lowered when the wind is blowing.
Awning's behaviour when the wind dropping
When the wind dropping, a manual lowering command
can be sent by the Somfy io control point
after 30 seconds. However all automated systems will still
remain locked for 11 mins.
6
PROG. G
1
on
H
my
30 sec
Copyright © 2010 Somfy SAS. All rights reserved.
2
PROG. H
my

Publicidad

Tabla de contenido
loading

Tabla de contenido