Publicidad
Idiomas disponibles
Idiomas disponibles
Installation instructions from the
back of the appliances
Fit connecting clamp at the top
over the middle two side walls.
Then fit the connecting bracket
into the appropriate gap below it.
Tighten connecting bracket firmly
with screw .
Warning: do not drill a hole for this
screw in the appliance!
Tip:
To avoid vibrations, neither the clamps,
brackets nor the screws should touch
the pipework on the back of the appli-
ances.
en - Installing in a side-by-side combination
Further installation instructions from
the front of the appliances
Danger of damaging the plinth
rollers.
When aligning the appliances by the
rear adjustable feet do not use a
power screwdriver. Doing so could
damage the height adjustment
mechanism or loosen the adjuster
rods. The adjustable feet must only
be adjusted by hand.
The front adjustable feet should be
adjusted using the spanner supplied
.
Adjust the central adjustable feet
so that they do not touch the floor.
Now align the whole side-by-side
combination with the outside ad-
justable feet .
27
Publicidad
