Publicidad
Idiomas disponibles
Idiomas disponibles
en - Installing in a side-by-side combination
Press the long piece of stainless steel
trim into the gap at the front
between the two appliances. Make
sure that it sits above connecting
bracket .
Tip: Pressing both ridges along the trim
together as you do so makes it easier to
fit the trim into the gap.
Carefully work the stainless steel trim
into the gap. Use a soft cloth to do
this to avoid denting the trim.
Carefully remove the protective foil
from the stainless steel trim.
Press the top edge of the short trim
into the gap. When doing so make
sure that the front edge of the trim is
flush with the edge of connecting
plate .
28
Fit cover in between the two con-
trol panels. Make sure that the out-
side edges of the cover are flush with
the control panels. The cover is ad-
justable for this purpose.
Fit cover from above onto the con-
necting bracket at the bottom of the
appliances at the front.
Connect both appliances to the elec-
tricity supply as described in their op-
erating instruction manuals under
"Electrical connection".
Appliances with ice cube maker:
plumb the appliance into the water
supply as described in the appli-
ance's operating instruction manual.
Warning! Danger of damage
when moving the appliance combin-
ation.
The weight of both appliances when
combined is very heavy. Incorrect
moving can cause dents!
Please observe the instructions on
how to move it.
The side-by-side combination must
be pushed very carefully into posi-
tion.
Publicidad
