Tabla de contenido
Publicidad
2.
Measure and mark a line 3 ½" from top end of middle pole (5). Note: Avoid scratching the paint on the pole.
While maintaining alignment, bounce middle pole section (5) into top section (4) using a wood scrap as shown
until the top pole is aligned with the marked line on the middle pole.
you should have 3 1/2" of overlap when properly assembled.
Align dimple of top pole section (4) into trough of middle pole
section (5) as shown.
Trough
3 1/2"
IMpoRTANT!
ID STICKER
MARKed lINe
dIMple
Hole
Wood scrap (not
supplied)
8
cAuTIoN!
WHeN pRopeRly
AsseMBled THe pole
secTIoNs sHould HAve A
3-1/2" oveRlAp.
5
4
Publicidad
Tabla de contenido
