SPALDING M6117044 Manual Del Propietário página 9

Measure and mark a line 3 ½" from top end of bottom pole (6). Note: Avoid scratching the paint on the pole. While
3.
maintaining alignment, Bounce top and middle pole assembly (4 and 5) onto bottom pole section (6) using a wood
scrap as shown. Bounce until the top and middle pole assembly is aligned with the marked line on the bottom pole,
you should have 3 1/2" of overlap when properly assembled.
Align dimple of middle pole section (5) into trough of bottom
pole section (6) as shown.
Trough
3 1/2"
IMpoRTANT!
ID STICKER
MARKed lINe
dIMple
Hole
WARNING!
duRING pole secTIoN AsseMBly,
THe pRe AsseMBled sTRuTs WIll
Need To Be secuRed usING TApe
oR oTHeR MeANs.
Wood scrap (not
supplied)
9
cAuTIoN!
WHeN pRopeRly
AsseMBled THe pole
secTIoNs sHould HAve A
3-1/2" oveRlAp.
4
5
6