Charging A Stand-Alone Battery - Motorola DTR Serie Manual De Instrucciones

Charging A Stand-Alone Battery

To charge a battery, insert the battery into the charger pocket by:
1. Aligning the raised tab on each side of the battery with the
corresponding groove on each side of the charger pocket.
2. Pressing the battery toward the rear of the pocket.
3. Sliding the battery into the charger pocket, ensuring complete
contact between the charger and battery contacts.
4. When the battery is properly seated in the pocket, the charger
indicates the Battery Level status as shown in Table 6. The RED
LED illuminates to indicate that the battery is charging rapidly.
5. The LED changes to a STEADY GREEN light to indicate that the
battery is nearly or fully charged.
Operating Instructions For DTR 6-Pocket Multi-Unit
Charger Kit
The charger pockets 1–6 will accommodate either a radio with battery
attached or stand-alone battery.
Prior to charging a battery with radio, turn off the radio. Batteries
charge best at room temperature.
1. This DTR 6-Pocket Multi-Unit Charger (MUC) Kit is able to charge
DTR Series radios with batteries, or radios with batteries and
holsters.
2. This DTR 6-Pocket Multi-Unit Charger (MUC) Kit is able to charge
stand-alone batteries as listed in Table 1.
1
2
6