Otto Bock C‑Leg 3C98-1 Manual De Instrucciones página 47

2b. Fine tuning of the standing angle (if required)
0°
7°
INFORMATION
Very slow extension (2b.): Actively standing up from sitting at this speed would take more than 5 seconds.
2c. Unblocking the standing angle
0°
7°
INFORMATION
Quick extension (2c.): Actively standing up from sitting at this speed would take less than 2 seconds. The
standing mode function remains turned on. A new standing angle can be selected at any time by repeating steps
2a./2b. 1st mode remains active.
Explanation of arrow symbols:
Flexion/Extension
Turning the standing mode function off:
1
INFORMATION
After the joint's confirmation with the beep signal, check whether the joint is still in the 1st mode (see Section
2.9.1).
1 To optimize the angle, very
slowly continue to extend the
joint (70 – 7°; Fig. 3).
2 The blocked joint can be fully
loaded in the flexion direction.
70°
3
1 The standing angle can be unblocked at any time by either a quick
extension movement or complete extension (7 – 0°, Fig. 4).
4
Very slow extension Slow extension
2
Quick extension
1 Activation of the remote control: Press key 3
and kep it pressed (Fig. 1) until the joint confirms the
activation with a vibration signal.
2 Turning the standing mode function off: Within
3 seconds after activation of the remote control si-
multaneously press the keys 1 and 2 (Fig. 2) until the
joint confirms turning off of the standing mode with
one short beep signal.
47