Opening The Web Application Via Wifi; Charging; Vehicle Charge Port; Starting Charging - Porsche 9Y0.012.003.A Manual De Instrucciones

Charging

To set up a hotspot:
DE
f Refer to chapter "Hotspot" on page 33.
EN e To open the web application while a hotspot is
active, enter the following IP address in the
FR
browser's address line: 192.168.0.1
IT
Opening the Web Application
ES
via WiFi
PT
The web application can be opened in the browser
NL
on a device (PC, tablet or smartphone) that is logged
into the same home network as the charger.
SV
e Enter the current IP address of the charger in the
FI
browser's address line. You will find the IP
address in S
ETTINGS
DA
.
INFORMATION
– or –
NO
e Enter the host name of the charger in the
EL
browser's address line. You will find the host
name in the letter containing access data.
CZ
HU
Charging
PL

Vehicle Charge Port

HR
SR For information on connecting and disconnecting the
vehicle cable to and from the vehicle charge port and
SK
for the charging and connection status at the vehicle
charge port:
SL
f Refer to the Driver's Manual.
ET
LT
LV
RO
BG
MK
34
Risk of serious or fatal injury due to fire or electric
shock.
e Always observe the specified order for the
charging procedure.
e Do not unplug the vehicle cable from the vehicle
charge port during charging.
e End the charging process before disconnecting
the vehicle cable from the vehicle charge port.
e Do not disconnect the charger from the electrical
socket during charging.
Errors are shown on the display and are indicated
by red status LEDs. The error message, the cause and
> N > N
ETWORK ETWORK
a remedial measure is displayed.
f Refer to chapter "Malfunctions" on page 36.

Starting Charging

1. Insert the plug into the electrical socket.
The display switches on.
2. Insert the vehicle plug in the vehicle charge port.
For information on connecting the vehicle cable
to the vehicle charge port:
f Refer to the Driver's Manual.
Following a successful self-test and when the
connection is established, the status LEDs light
up white.
3. Charging starts automatically.
Electric shock, fire
DANGER
Power button lights up white.
Status LEDs light up white.
Power button lights up white.
Status LEDs pulsate white.
Power button lights up white.
Status LEDs pulsate green.
4. After a few minutes, the charger switches
to standby mode.
The vehicle starts charging.
Information
– Charging is controlled by the vehicle.
Charging can only be stopped on the vehicle.
– Unless the charger is in standby mode, the charge
status is shown on the display. The display can
be switched on again by pressing the Power
button .
– An overtemperature switch-off feature prevents
overheating while charging.

Pausing Charging

Charging is controlled by the vehicle and may
occasionally be paused, e.g. to optimise power
consumption.
A pause in charging is indicated on the control unit:
Power button lights up white.
Status LEDs flash blue.
The display switches on.
The vehicle starts charging again automatically.
Charging can be stopped on the vehicle.

Stopping Charging

b Charging was completed successfully.
Power button lights up white.
Status LEDs light up green.
The display switches on and shows information
about the completed charging process.
After a few minutes, the charger switches
to standby mode.
e Disconnect the vehicle plug from the vehicle
charge port.