Get Started - Silk’n Infinity Manual Del Usuario

8.

Get started!

8.1 Connect the device
EN
1. Remove the device and other components from the box.
Place the adapter cable into the device and connect to the electricity
2.
supply. All the energy level indicator lights will go on and off repeatedly
in a circular motion.
8.2 Do a spot test
It' s important to do a spot test on each part of the body you wish to treat. A spot
test checks that the skin colour is suitable for treatment, and that you know which
energy level is comfortable for the area you are treating. Both skin colour and
energy level may vary depending on the target treatment area.
1. To do a spot test, follow steps 1-5 and 7-9 in the next section.
2. Continue testing at increased energy levels until you have reached the
highest level that you feel comfortable with. If within one hour you
experience no adverse effects, you can start your full treatment at that
energy level.
3. Repeat the spot test for each area you wish to treat.
8.3 Treatment steps
1. Remove all jewellery before use.
2. Before treatment, the skin should be shaved, clean, dry and free of any
powders, antiperspirants or deodorants. Do not wax, pluck or tweeze the
hair out.
3. Be sure to cover up tattoos, moles, warts or other marks on the skin that
should not be treated. Use a material that does not absorb the light such as
a white cloth or white medical tape.
Press the control button. The device will turn on, the level 1 energy level
4.
indicator light will be on, and a fan sound will start.
Approximately 1 second after pressing the control button, the ready/skin
5.
tone warning indicator light (green) will turn on. The device is now ready
for you to trigger the first pulse at the lowest energy level. Always start at
energy level 1 for your first treatment.
6. Select the energy level you are most comfortable with.
16