Meanings Of Symbols - Hitachi Koki CG28EJ Instrucciones De Manejo

Meanings of symbols

NOTE : Some units do not carry them.
It is important that you read, fully understand
and observe the following safety precautions and
warnings. Careless or improper use of the unit
may cause serious or fatal injury.
Read, understand and follow all warnings and
instructions in this manual and on the unit.
Always wear eye, head and ear protectors when
using this unit.
Do not use metal/rigid blades when this sign is
shown on the unit.
Keep all children, bystanders and helpers 15m
away from the unit. If anyone approaches you,
stop the engine and cutting attachment imme-
diately.
Be careful of thrown objects.
Fuel and oil mixture.
Explains choke position. Upper sign indicates
choke closed and the lower fully open.
Carburetor adjustment - Low speed mixture
Priming pump
Before using your machine
• Read the manual carefully.
• Check that the cutting equipment is correctly assembled and adjusted.
• Start the unit and check the carburetor adjustment. See "Maintenance".
(Original instructions)
Symbols
WARNING
The following show symbols used for the machine. Be sure that
you understand their meaning before use.
Index
What is what? ................................................................
Warnings and safety instructions ..................................
Specifications ................................................................
Assembly procedures ....................................................
Operating procedures ...................................................
Maintenance ..................................................................
Shows maximum shaft speed. Do not use the
cutting attachment whose max rpm is below the
PLQ 
shaft rpm.
Gloves should be worn when necessary, e. g.,
when assembling cutting equipment.
Use anti-slip and sturdy footwear.
Blade thrust may occur when the spinning blade
contacts a solid object in the critical area. A
dangerous reaction may occur causing the entire
unit and operator to be thrust violently. This
reaction is called BLADE THRUST. As a result,
the operator may lose control of the unit which
may cause serious or fatal injury. Blade thrust is
more likely to occur in areas where it is difficult
to see the material to be cut.
Indicate handle location. Do not attach handle
above this point.
Do not touch the muffler and surrounding area
as they can be very hot.
Carburetor adjustment - Idle speed
Carburetor adjustment - High speed mixture

Guaranteed Sound power level
2
3
4
5
6
7
*
%
GB-1