Tabla de contenido
Publicidad
q
w
q
w
t
Tricot Stitch
e
q Pattern selector:
w Presser foot:
e Thread tension:
This stitch is used to finish the raw edge on
synthetics and other fabrics that tend to pucker.
Place your fabric to allow a 1.6 cm (5/8") seam.
Trim the seam allowance after sewing.
Be careful not to cut the stitches.
Sewing Buttons
e
q Pattern selector:
w Presser foot:
e Thread tension:
r Feed dog:
Drop the feed dogs. Match the holes in the
button with the horizontal slot on the presser
foot. Choose a pattern width matching the
distance of the holes in the button. Lower the
foot to hold the button in place. Check to see if
the needle enters into the holes in the button by
turning the handwheel by hand. Sew about ten
(10) stitches.
To strengthen the shank, cut the threads leaving
about 4.0˝ (10.0 cm). Bring the needle thread
down through one of the holes in the button and
wind it around the shank. Bring the needle
thread to the wrong side (bottom side) and knot.
After button sewing is completed, raise the feed
dogs for normal sewing.
26
D
Zigzag foot
1–4
C1 – C3
Zigzag foot
3–7
Dropped
Publicidad
Tabla de contenido
