Class 1 Laser Product; Product Overview - Hach HHPC 6+ Manual Del Usuario

Certification
Canadian Radio Interference-Causing Equipment Regulation,
IECS-003, Class A:
Supporting test records reside with the manufacturer.
This Class A digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
Cet appareil numèrique de la classe A respecte toutes les exigences du
Rëglement sur le matériel brouilleur du Canada.
FCC Part 15, Class "A" Limits
Supporting test records reside with the manufacturer. The device
complies with Part 15 of the FCC Rules. Operation is subject to the
following conditions:
1. The equipment may not cause harmful interference.
2. The equipment must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications to this equipment not expressly approved by
the party responsible for compliance could void the user's authority to
operate the equipment. This equipment has been tested and found to
comply with the limits for a Class A digital device, pursuant to Part 15 of
the FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference
to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference, in which case the user will be
required to correct the interference at their expense. The following
techniques can be used to reduce interference problems:
1. Disconnect the equipment from its power source to verify that it is or
is not the source of the interference.
2. If the equipment is connected to the same outlet as the device
experiencing interference, connect the equipment to a different
outlet.
3. Move the equipment away from the device receiving the interference.
4. Reposition the receiving antenna for the device receiving the
interference.
5. Try combinations of the above.

Class 1 laser product

This instrument is classified as a Class 1 laser product. This product
complies with IEC/EN 60825-1:2007 and 21 CFR 1040.10 except for
deviations pursuant to Laser Notice No. 50, dated June 24, 2007.
US FDA Laser Accession number 9922627-004. This product contains a
non user-serviceable 760-850nm 50 mW class 3B laser.

Product overview

Note: The instrument is designed for indoor use only. Do not place the instrument
in direct sunlight.
The handheld particle counter is a portable instrument that is used to
monitor the air quality in:
• Clean rooms
• Manufacturing processes
• Pharmaceutical production
Three models of the instrument are available. The main differences are
given in Table 1.
The cradle keeps the instrument in an upright position while the
instrument is in use or in storage and while the battery charges. The
cradle also has data and power connections. Refer to
on page 7.
Table 1 HHPC models
HHPC 6+ HHPC 3+
(0.3 µm)
Cradle
Standard
accessory
Sensitivity 0.3 µm
Number of 6
channels
Figure 2
HHPC 3+ HHPC 2+
(0.5 µm)
Optional Optional Optional
0.3 µm 0.5 µm 0.5 µm
3 3
English 5
2