Dust Extraction; Working With The Electric Power Tool - Festool HK 85 EB Manual De Instrucciones

WARNING
Risk of injury
If a clamping flange is loose, the cutting
edges of the saw blade may break off, and if
a screw is loose, the saw blade may become
detached.
► Whenever you replace a saw blade, always
check that it is securely in place.
7.7

Dust extraction

WARNING
Heath hazard posed by dust
► Always work with an extractor.
► Comply with national regulations.
Independent extraction
► Secure the connection piece of the dust
collection bag at the extractor connector
with a clockwise rotation .
► To empty remove the connection piece of
the dust collection bag from the extractor
connector with an anti-clockwise rotation .
Festool mobile dust extractor
A Festool mobile dust extractor with an extrac­
tor hose diameter of 27 mm or 36 mm (36 mm
recom-mended due to the reduced risk of clog­
ging) can be connected to the extractor connec­
tor
The adapter on a suction hose Ø 27 is inserted
into the angle adapter . The adapter on a suc­
tion hose Ø 36 is inserted over the angle adapt­
er .
Static charge may occur if an anti-static suction
hose is not used. The user may suffer an elec­
tric shock.
8 Working with the electric
power tool
Please observe all mentioned safety in­
formations and the following rules when
working:
– Only guide the machine against the work­
piece when it is switched on.
– Check the function of the pendulum guard
prior to use and do not use the electric
power tool if it does not slide in and out
easily.
– Always secure the workpiece in such a
manner that it cannot move while being
processed.
– Always hold the machine with two hands at
the handles [1-1] when performing work.
This reduces the risk of injury and is a pre­
requisite for precise work.
– Always push the saw forwards [7-9], and
never towards yourself.
– Adapt the infeed speed to prevent the cut­
ters on the saw blade from overheating and
prevent plastic materials from melting dur­
ing cutting.
– Make sure that the knob [1-12] is tightened
before starting work.
– Do not use the machine when the electron­
ics are faulty because the machine may op­
erate at excessive speeds. An absence of
the smooth start-up function or speed con­
trol indicates that the electronics are faul­
ty.
8.1 Sawing along the scribe mark
The cut indicators display the cutting sequence
without a guide rail:
0° cuts: [6-1]
45° cuts: [6-2]
8.2 Cutting sections
Position the saw with the front part of the saw
table on the workpiece, switch on saw and push
forward in cutting direction.
8.3 Sawing cut-outs (plunge cuts)
In order to avoid kickbacks, the following
instructions must be observed without fail when
plunge cutting:
– Always position saw with the rear edge of
the saw table against a fixed stop.
– When working with the guide rail, place the
saw against the kickback stop FS-RSP (ac­
cessories) [7-7] clamped to the guide rail.
CAUTION
Danger of crushing
► Always keep a firm grip on the machine
with your free hand when adjusting plunge
cuts.
► Never position your fingers behind or be­
low the saw blade.
Procedure
► Adjusting cutting depth, see section
► Press lever [7-1] down.
Sawing unit swivels upwards to plunge-cut
position.
► Hold retractor lever [7-2] downwards as far
as stop.
English
7.2 .
23