Bosch PowerPack 400 Manual Del Propietário página 123

English–7
Setting the Assistance Level
On the on-board computer you can set how much the eBike
drive assists you while pedaling. The assistance level can
be changed at any time, even while cycling.
Note: For individual versions, it is possible that the assis-
tance level is preset and cannot be changed. It is also pos-
sible that fewer assistance levels are available for selection
than listed here.
Once it is switched on, the eBike system is in the "OFF"
mode.
The following assistance levels (max.) are available:
– "OFF": The motor assistance is switched off, the eBike
can be operated as a normal bicycle through pedaling.
– "ECO": Effective assistance at maximum efficiency for
maximum cruising range
– "TOUR": Uniform assistance, for touring with long cruis-
ing range
– "SPORT": Powerful assistance for sporty off-road rid-
ing, as well as for urban traffic
– "TURBO": Maximum assistance, supporting the highest
speed for sporty riding
To increase the assistance level, short-press
"+" 6 on the on-board computer repeatedly until the re-
quired assistance level appears in indicator i. To decrease
the assistance level, short-press
Switching bike lights On/Off
In the version which has the bike lights powered by the
eBike system, medium-press
on the front and rear lights at the same time. To switch off
the bike lights, long-press
The lighting symbol h is displayed when the light is on.
Switching the driving light on and off has no effect on the
backlighting for the display. The backlighting for the display
is active as soon as the system or the display is switched on.
1 270 U20 XBP | (21.4.16)
the button
the button "–" 5.
the button "+" to switch
the button "+".
Speed and Distance Indicator
j
i
h
The speed indicator a always displays the current speed.
Indicator i always displays the last setting as standard. Re-
peatedly medium-press
distance "TRIP", the total distance "TOTAL" and the range of
the battery pack "RANGE" one after the other. (Short-
pressing the button "–" will decrease the assistance level!)
The trip distance "TRIP" is reset by simultaneously long-
pressing the buttons "+" and "–". The display will initial-
ly show "RESET". If you continue to press both buttons, the
trip distance "TRIP" will be set to "0".
You can switch the displayed values from kilometers to
miles by holding down button "–"
the On/Off button 1
The versions of the subsystems can be displayed for the
purposes of servicing. With the system switched off, si-
multaneously press buttons "–" and "+" and then press the
On/Off button 1 .
The USB socket is reserved for connecting diagnostic sys-
tems. The USB socket does not have any other function.
 The USB connection must always be completely
sealed with the protective cap 8.
122
a
g f
the button "–" to display the trip
and briefly pressing
.
Bosch eBike Systems
b
c
d
e