Charging Procedure - Bosch PowerPack 400 Manual Del Propietário

English–7
Charging the Battery on the Bike
7
5
Switch the battery off. Clean the cover of the charge socket
7. In particular, prevent the charge socket and the contacts
from getting dirty, e.g., with sand or soil. Lift the cover of
the charge socket 7 and plug the charge connector 5 into
the charge socket 6.
 Charge the battery only in accordance with all safety
instructions. If this is not possible, remove the battery
from the holder and charge it in a more suitable location.
When doing so, read and follow the operating instruc-
tions for the battery.
0 275 U07 XCX | (25.4.16)
11
8
6
7
5
Charging with Two Battery Packs Inserted
If two battery packs are mounted on one eBike, both bat-
tery packs can be charged using the unsealed connection.
The charging process will charge both battery packs alter-
nately, automatically switching between both battery
packs numerous times. The charging times add up.
Both battery packs are also discharged alternately during
operation.
If you take the battery packs out of the holders, you can
charge each battery pack individually.

Charging Procedure

The charging procedure begins as soon as the charger is
connected to the battery or the charge socket on the bike
6
and the main power supply.
Note: The charging procedure is only possible when the
temperature of the eBike battery pack is within the permis-
sible charging temperature range.
Note: The drive unit is deactivated during the charging pro-
cedure.
The battery can be charged with or without the on-board
computer. When charging without the on-board computer,
the charging procedure can only be observed on the bat-
tery charge-control indicator.
If the on-board computer is connected, a corresponding
message will be output on the display.
The charging state is displayed by the battery charge-con-
trol indicator 9 on the battery and by the bars on the on-
board computer.
During the charging procedure, the LEDs for charge-control
indicator 9 on the battery pack light up. Each continuously
lit LED is equivalent to a charge capacity of approx. 20 %.
The flashing LED indicates the charging of the next 20 %.
Once the battery is fully charged, the LEDs extinguish imme-
diately and the on-board computer is switched off. The
charging procedure is terminated. The charging state can be
displayed for 3 seconds by pressing the On/Off button 10.
Disconnect the charger from the main power supply and
the battery pack from the charger.
When disconnecting the battery pack from the charger, the
battery pack is automatically switched off.
Note: If you have charged on the bike, carefully close the
charge socket 6 with the cover 7 after the charging proce-
dure so that no dirt or water can get in.
If the charger is not disconnected from the battery after
charging, after a few hours the charger will switch itself
back on, check the charging state of the battery and begin
the charging procedure again if necessary.
200
Bosch eBike Systems