Buttons - Elinchrom EL-Skyport Manual De Funcionamiento

User Manual

BUTTONS

Speed button 2
Speed button 1
EN
SR
USB
Group selection
Test
Rotation ring / Dial
Change value
Press for 2 seconds
SPEED BUTTONS 1-4
The Speed Buttons enable quick setting of the functions indicated below. Functions in Bold type indicate the
function of these buttons when SETUP mode is selected.
SPEED BUTTON 1 (LEFT)
Pwr± change the flash power in 1/10 f-stop up/down with the dial.
up scroll up in the setup menu when SETUP is selected.
SPEED BUTTON 2 (MIDDLE LEFT)
Press this button once or twice to toggle between the modelling lamp features.
Mod switch the modelling lamp on/off with the dial.
Mod± change the modelling lamp power in 1/10 f-stop up/down with the dial.
down
scroll down in the setup menu when SETUP is selected.
SPEED BUTTON 3 (MIDDLE RIGHT)
Select toggle between the displayed (found) Elinchrom flash units.
Flash and modelling lamp settings can be individually adjusted on the selected flash unit, when highlighted
with a frame.
After approx. 5 seconds the frame will disappear and adjustments in the settings will affect all units in all
Groups, when Group "ALL" is selected. If Group 1 – 4 is selected only the flash units in that Group will be
modified.
12
Speed button 3
Green LED
Communication Transmitter
Speed button 4
HS / EL- flash unit.
Refresh
To refresh manual
changes made on the flash unit
Battery compartment cover
On/Off
Press for 2 seconds
Set
Blue LED
Lock
Communication camera / Transmitter HS
SPEED BUTTON 4 (RIGHT)
Setup by pressing this button the functions of the speed buttons will change and the SETUP menu is
selected. In the SETUP menu features can be adjusted and activated.
Exit Exit the Setup menu and switch back to standard display mode.
ON/OFF
Press and hold for min. 2 seconds to switch the EL-SkyportTransmitter Plus HS On/Off.
GROUP BUTTON
Press to toggle between 1 through 4 groups and "ALL."
TEST BUTTON (WITH EL LOGO)
Pressing the TEST button will fire all flashes when "ALL" is selected or any single group, 1 through 4 is
selected. Please remember to deactivate photocells for accurate
EL-Skyport triggering of your flash units.
REFRESH BUTTON
Press the Refresh button any time power setting has been done on a separate EL flash unit to update the
power setting display of the Skyport HS.
If a Group is selected, only the information for that selected Group will refresh.
When "ALL" is selected, information for all groups will be refreshed.
A flash that was not scanned and found when the Skyport HS was switched ON cannot be added with the
Refresh feature.
If a flash is added, select SETUIP and SCAN in the setup menu or switch the transmitter OFF and ON again.
The refresh can take up to 4 seconds, depending on how many flash units are found and operated by the
transmitter.
Note:
To assure the most positive operation between the Skyport HS and EL flashes, flash power information is
transmitter by the EL flash only when power level changes are made or the Refresh button is pressed.
ROTATING RING / DIAL
Turn the Dial to select various functions and change power levels of the EL flashes.
SET / CONFIRMATION BUTTON (DIAL CENTRE BUTTON)
Press to confirm a modification made in the Setup menu.
Press to switch on the display illumination.
Press to return to normal operation when Skyport HS has switched to Standby mode.
Press 2s to lock all functions and settings. Press again to unlock.
The locking feature blocks the function of the dial and other buttons to prevent mis-setting while carrying the
Skyport HS.
User Manual
EN
13