Cabinet Requirements; Proper Use; Electrical Connection - Franke MYTHOS FMY 839 HI Manual Del Usuario

EN

Cabinet requirements

The cooking hob is intended to be built
Z X
into the worktop above a kitchen cabinet
of 600 mm width or more.
If fitting in flammable material, the
Z X
guidelines and standards for low voltage
installations and for the fire protection
must be strictly observed.
For fitted units, the components (plastic
Z X
materials and veneered wood) must be
assembled with heat-resistant adhesives
(min. 100 °C): Unsuitable materials and
adhesives can result in warping and
detachment.
The kitchen cabinet must allow sufficient
Z X
room for the electrical connections of the
appliance. Suspended kitchen cabinets
above the appliance must be installed at
a distance that provides enough room for
comfortable working process.
The use of hard wood decorative borders
Z X
around the worktop behind the appliance
is allowed, in this case the minimum
distance remains as indicated on the
installation illustrations.
The minimum distance between the built-in
Z X
appliance and rear wall is indicated at the
illustration for the installation of the built-in

ELECTRICAL CONNECTION

The wire connection has to be done by specialized
Z X
technician.
This appliance has a Type "Y" attachment and requires
Z X
at least a power supply cord Type H05VV-F. MONO-
PHASE, BI-PHASE and THREE-PHASE connection: min.
section of the conductors: 2,5 mm². External diameter
of the supply cord: min. 7 mm - max. 15 mm
Connection terminals are revealed when the
Z X
connection box cover is removed.
Make sure the characteristics of the household electrical
Z X
system (voltage, maximum power and current) are
compatible with those of the appliance.
FMY 839 HI
appliance (150 mm for the side wall,
40 mm for the rear and 500 mm minimum
for any cabinets above it).
To prevent leakage of liquid between the
Z X
edge of the hob and the countertop, place
the adhesive seal provided along the entire
outer edge of the hob before assembly.

Proper use

The extractor appliance has been designed
Z X
exclusively for domestic use to eliminate
kitchen smells.
Never use the appliance for purposes
Z X
other than for which it has been designed.
Deep fat fryers must be continuously
Z X
monitored during use: overheated oil can
burst.
Do not operate the appliance with an
Z X
external time switch or a separate remote
control system.
The appliance shall not be installed
Z X
behind a decorative door in order to avoid
overheating.
To avoid damaging the appliance do not
Z X
climb onto the appliance.
To avoid damaging the silicon grouting, do
Z X
not put hot cookware on the frame.
Do not cut or prepare food on the surface
Z X
or drop hard objects onto it. Do not drag
cookware across the surface.
Connect the appliance like shown in the diagram
Z X
(in accordance with the mains voltage and country
standard reference).
We suggest to use power supply cord 5 x 2.5 mm²
Z X
H05V2V2-F. In case of use of power supply cord
5 x 2,5 mm² H05V2V2-F, below instructions have to
be followed: for three-phase connection separate the
2 wires and remove the blue sheaths on grey wires.
– 6 –