Adjusting The Knee Pad Height - Invacare Stand Assist Manual Del Usuario

Invacare® Stand Assist
E Mast mounting bracket
F Lift arm
WARNING!
– DO NOT overtighten the mounting hardware. This
will damage mounting brackets.
1. Remove the bottom nut, washers, shoulder bolt and bushing that
secure the electric actuator to the mast mounting bracket.
2. Rest the lift arm on your shoulder and remove the top nut, bolt,
bracket, bushing and washers from the lift arm mounting bracket.
3. Remove the electric actuator.
4. Reverse STEPS 1–3 to install the new electric actuator.

8.8 Adjusting the Knee Pad Height

A Knee pad
40
K Lift arm mounting bracket
B Adjustment pins
WARNING!
– NEVER adjust the knee pad while patient is in the
standing position.
– NEVER try to adjust the knee pad while the lift is
moving.
– ALWAYS make sure that the adjustment pins are
engaged in corresponding height adjustment holes
before use.
1. Pick a height setting that will be comfortable to the patient and
provide the necessary support.
The knee pad should be positioned so that the knee
portion of the leg is in contact with the pad.
2. Using both hands, pull both adjustment pins outward at the
same time.
3. Position the knee pad to the desired height and release
adjustment pins into the corresponding alignment holes.
4. Check to make sure that both pins are engaged.
1078985-G