Sears Kenmore 75865 Manual De Uso página 21

Operating the Self-Cleaning Oven .or S Ti e: 4 hour
Before a Clean Cycle
Quick Reminder:
1. Prepare the oven for cleaning.
2. Close and latch the oven door.
3. Press the CLEAN pad,
4. Press the INCREASE pad.
If you wish to change preset clean time of 4
hours, press the INCREASE or DECREASE pad
until the desired Stop Time appears in the displayo
We recommend venting with an open window
or using a ventilation fan or hood during the first
self-clean cycle.
1. Remove the broiler pan, broiler grid, all cookware
and any aluminum foi! from the oven--they cannot
withstand the high cleaning temperatures_
NOTE: Take the shelves out of the oven before you
begin the self-clean cycle.
2. Wipe up heavy soil on the oven bottom. If you use
soap, rinse thoroughly before self-cleaning to
prevent staining.
Area inside Oven door
gasket gasket gasket
3. Clean spatters or soi! on the oven front frame and
the oven door outside the gasket with a dampened
cloth. The oven front frame and the oven door out-
side the gasket do not get cleaned by the self-
clean cycle° On these areas, use detergent and hot
water or a soap-filled steel wool pad. Rinse well
with a vinegar and water solution° This will help
prevent a brown residue from forming when the
oven is heated_ Buff these areas with a dry cloth.
Do not clean the gaskeL
Do not use abrasives or oven cleaners. Clean
the top, sides and outside front of the oven door
with soap and water_
Make sure the oven light bulb cover is in place.
Do not rub or clean the door gasketmthe fiber-
glass material of the gasket has an extremely low
resistance to abrasion. An intact, well*fitting oven
door gasket is essential for energy-efficient oven
operation and good baking results. If you notice the
gasket becoming worn, frayed or damaged in any
way or if it has become displaced on the door, you
should have it replaced.
4. Close the oven door and make sure the oven
light is off. If the oven light is not turned off,
the life of the bulb will be shortened or it may
burn out immediately° The door latches automati-
cally after the clean cycle is set.
CAUTION: The grates and drip pans (on some
models) should never be cleaned in the self-clean-
ing oven.
Do not use commercial oven cleaners or oven
protectors in or near the self-cleaning oven.
A combination of any of these products plus the high
clean cycle temperatures may damage the porcelain
finish of the oven.
How to Set Oven for Cleaning
1_ Follow the directions in the Before a Clean Cycle
section.
2. Close the oven door and
slide the latch handle to the
IIIIi1|1
right as far as it will go_
-r
Never force the door latch handle. Forcing the
handle may damage the door lock mechanism.
3. Press the CLEAN pad.
4. Press the INCREASE or DECREASE pad until the
desired Clean Time is displayed.
Clean Time is normally 4 hours. You can change
the Clean Time to any time between 2 and 4 hours,
depending on the amount of soil in your oven. The
self-clean cycle will automatically begin within a few
seconds after the word "CLEAN" is displayed and
the word "ON" appears in the display. When the
oven heats to a high temperature, the word "LOCK"
will be displayed and, a short time later, the door
latch handle wilt be locked in position. It will not be
possible to open the oven door until the tempera-
ture drops below the lock temperature_
5. When the LOCK light is off, slide the latch handle
to the left as far as it will go and open the door°
(continued next page)
21