Check For Leaks - Sears Kenmore 75865 Manual De Uso

Converting to LP Gas (continued)
Step 5
Check for Leaks
When al! connections have been made, make sure all
range controls are in the off position and turn on the
main gas supply valve. Use a liquid leak detector
at all joints and connections to check for leaks in the
system°
1
CAUTION: DO NOT USE A FLAME TO CHECK |
FOR GAS LEAKS.
]
When using test pressures greater than 1/2 psig to
pressure test the gas supply system of the residence,
disconnect the range and individual shut-off valve
from the gas supply piping. When using test pres-
sures of 1/2 psig or less to test the gas supply sys-
tem, simply isolate the range from the gas supply
system by closing the individual shut-off valve.
Step 6
Convert Top Burner Valves
NOTE: Only valves with these types of
knobs are adjustable.
I
'I.
2.
3.
1
5,
J
Turn all of the top burners to LOW°
Remove all 4 knobs.
With a small flat blade _
screwdriver, turn the _
valve set screws clock-_ ee _--_"_
wise to decrease flame _llk_
size, counterclockwise to "_"_ _/'_1
increase flame size. %
I!1
Adjust until the flame is
about the same height as "_-_f'--j
the top of the burner° " '
Replace the knobs.
Check for flame outage by opening and closing the
oven door several times_ If the flame goes out,
increase the flame size.
Look at the flame& With LP gas, some yellow tip-
ping on the outer cones is normal. Refer to Step 5
in the Installation Instructions°
44