Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Converting to LP Gas (cont no d)
If It Is This Regulator:
Gas Flow
into Ran,
Do not
remove this
protectiveca
exceptfor
conversion
Lever shown closed
PULL TO OPEN
Cap AssembLy
1. Unscrew
the plastic-protected
hex-nut
cap from the
regulator.
2. Carefully
pry
the
protective
plastic
cap
off the
threaded
metal cap. Gently pull the plastic washer
off the threads
on the other side of the metal cap.
3. Push the plastic
cap onto the end of the metal cap
displaying
the type of gas you are converting
too
Press the attached
plastic washer
onto the threads
on the other side of the metal cap_
4. Screw the hex-nut
cap back into the regulator,,
Do
not overtighten.
Step
2
Convert The Surface Burners
Follow the directions
in A for Sealed
Burner
Models
(models
without
lift-up cooktops)
or B for Standard
Twin Burner
Models
(models with lift-up cooktops)o
A Sealed Burner Models
(models without I_-up cooktops)
Grate
Burner Cap
Drip Pan (on some modefs)
Burner Head
\ '_
Electrode
1. Remove
grates,
burner caps and burner heads,,
2,
Remove
the brass orifice spud
_/,
2_ /
inside
the
chimney
of
each
_F. °
burner
using
a 9/32"
or 7 mm
eye'
nut driver.
3. Install the orifice
spuds accord-
Chiton
%
ing to one of the following
dia- /._.._--_.
grams
(see []
or [])
for LP gas
//'_.
or natural
gas,
depending
on
which you are converting
to.
Orifice Spud
[_
Orifice
Spuds
for Converting
to LP Gas:
LP orifice spuds are in a small plastic bag packed with
this Use and Care Manual° LP orifice spuds have a 2-
digit number
and the letter "L" on top, Each orifice
spud
will also
have
1, 2 or 3 grooves
on the top,
denoting
the location
on the range where it is to be
installed as shown
below.
Front of Range
[-_ Orifice
Spuds for Converting
to Natural
Gas:
Natural
gas orifice spuds
have a 3-digit number
and
the letter "N" on the top_ Each orifice
spud will also
have
1, 2 or 3 grooves
on top denoting
the location
on the
range
where
it is to be installed
as shown
below°
Front of Range
4. To prevent
leakage,
make sure
the orifice
spuds
are securely
screwed
into the gas inlet tubes.
5. Put old orifice spuds
back in the bag to save for
possible
future conversion.
NOTE:
If an orifice spud is acci-
dentally
dropped,
the cooktop
can be raised by disengaging
the
2 front clips with a large flat blade
screwdriver.
When
lowering
it, make sure it snaps over the clips°
42
Publicidad
Tabla de contenido
