Sears Kenmore 75865 Manual De Uso página 43

B Standard Twin Burner Models
(models with lift-up cooktops)
1, Lift the cooktop.
2. Lift the burner
assemblies
straight up and
set aside to gain
access to sur-
face burner
spuds°
3. With a 7mm,
5/t6" or a small
adjustable
wrench (depend-
ing on the size
needed), remove each of the four spuds on the sur-
face burner gas inlet tubes and replace them with
the correct gas spuds mounted in a holder at the
right rear of the range, above the regulator_ Natural
gas spuds are brass and LP gas spuds are red or
silver. (Mount the spuds that you removed from the
inlet tubes back in the holder°) To prevent leakage,
make sure spuds are securely screwed into gas
inlet tubes_
4. Replace the burner assemblies,
5. Keep all spuds with your range so you have them if
you move or get a different gas hook-up.
Top Burner Orifice Drill Size Color
Natural Gas #54 (_0550 Diao) Brass
LP (Propane) #66 (_0330 Dial) Red or Silver
Step 3
Convert the Oven Burner Orifices
Oven Burner
1. Remove oven door, storage drawer or broiler draw-
er and oven bottom. The lower burner orifice spud
is located behind the storage drawer, broiler drawer
or kick panel. (On some models, a metal shield
must be removed to access the orifice.)
2. To convert to LP gas, use a
1/2" wrench to turn the lower
burner orifice spud clockwise_
Tighten the spud only until it is
snug° To prevent damage, do
not overtighten the spud.
To convert to natural gas,
loosen the spud about 2 turns°
Broil Burner (on some models)
To convert to LP gas, use a 1/2" wrench to turn the
upper burner orifice spud clockwise° Tighten spud
only until it is snug with the base, To prevent damage,
do not overtighten spud.
To convert to natural gas, loosen the spud about
2 turns,
Step 4
Convert Air Adjustment Shutter(s)
head screw and rotate the shut-
ter to the full open position. With
baffle in place, flames should
have approximately 1" (2°5 cm)
Screw
blue cones and should not
Air
extend beyond the edges of the Shutter
burner baffle. After 30 seconds _-
of burner operation, check for
flames lifting off burner ports. If lifting is observed,
gradually reduce air shutter opening until flames are
stabilized.
For natural gas, the shutter should be open 1/2"
(1.3 cm) or about 3/4 of the way open.
(continued next page)
43