Sears Kenmore 75865 Manual De Uso página 22

Operating the Self-Cleaning Oven tooot oo d
To Stop a Clean Cycle
1° Press the CLEAR!OFF pad°
2o When the lock light goes off, open the door.
After a Clean Cycle
When the clean cycle is finished, the word "CLEAN"
will go out in the display and the oven will begin to
cool. When the oven temperature has fallen below the
locking temperature the word "LOCK" goes out and
the door can be opened.
After a clean cycle, you may notice some white ash in
the oven. Just wipe it up with a damp cloth. If white
spots remain, remove them with a soap-filled steel
woo! pad. Be sure to rinse thoroughly with a vinegar
and water mixture° These deposits are usually a salt
residue that cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle, the cycle
may be repeated°
How to Delay Start of Cleaning
Delay Start is setting the oven timer to start the clean
cycle automatically at a later time than the present
time of day.
NOTE: Before beginning, make sure the oven clock
shows the correct time of day.
Quick Reminder--Delay Start for
Self-Clean:
1, Prepare the oven for cleaning°
2. Close and latch the oven door.
3. Press the CLEAN pad.
4, Press the INCREASE pad° tf you wish to
change preset clean time of 4 hours, press the
INCREASE or DECREASE pad until the
desired time appears_
5. Press the STOP TIME pad.
Time that appears is 4 hours later than the time of
day. Press the INCREASE pad until the Stop
Time you desire appears in the display. The self-
clean cycle will automatically begin 4 hours
before the Stop Time you select.
For example: Let's say it's 7:00 and you want the
oven to begin self-cleaning at 9:00 after you're fin-
ished in the kitchen° The oven has been preset to
clean for four hours.
1. Follow the directions in the Before a Clean Cycle
section.
illlllll
2. Close the oven door and slide
the latch handle to the right
as far as it will go. Make sure
the oven light is off.
Never force the door latch handle. Forcing the
handle may damage the door lock mechanism.
3. Press the CLEAN pad°
4. Press the INCREASE pad. The oven is set.
5. Clean Time is preset for 4 hours_ You can change
the clean time to any time between 2 and 4 hours,
depending on the amount of soil in your oven. If a
shorter Clean Time is desired, press the
DECREASE pad until the desired Clean Time is
displayed_
6. Press the STOP TIME pad° "11:00" appears
in the display and "STOP TIME" flashes.
The control automatically sets the Stop
Time by adding the Clean Time to the time
of day. In this example, the time of day is
7:00 and the Clean Time is 4 hours. Adding
4 hours to the time of day equals 11:00.
7. Change the Stop Time from 11:00 to 1:00 by press-
ing the INCREASE pad until "1:00" appears in the
display_ The words "DELAY CLEAN" will also
appear in the display.
The self-clean cycle will automatically begin at 9:00
and finish at 1:00. The word "ON" will appear in the
display at 9:00.
When the oven locks, the word "LOCK" will be dis-
played and a short time later, the door latch handle
will be locked in position. It will not be possible to open
the oven door until the temperature drops below the
lock temperatureo
When the clean cycle is finished, the word "CLEAN"
will go out in the display and the oven will begin to
cool. When the oven temperature has fallen below the
locking temperature the word "LOCK" goes out and
the door can be opened.
8. When the LOCK light is off, slide the latch handle
to the left as far as it will go and open the door.
Never force the latch handle. Wait until the word
"LOCK" goes out in the display. Forcing the latch
handle may damage the door lock.
22