THE PROBLEM SOLVER
(continued)
PROBLEM
POSSIBLE
CAUSE
SURFACE
BURNERS
LIGHT BUTOVEN
DOES NOT
• The oven gas shut off valve may have accidentally
been moved during
cleaning
or moving.
To check the oven gas shut off valve on standard
twin burner models,
raise
the cooktop
and look for the gas shut off lever at the extreme
right rear corner.
Follow the directions
in box A or B that match your regulator
type.
Lever shown closed/
PULL TO OPEN./
StandardTwin
Burner Models
i
Lever shown closed//
PULL TO OPEN j
Standard
Twin Burner Models
SURFACE
L1GHT DOES
NOT WORK
OVEN WILLNOT
SELF-CLEAN
OVEN DOOR
WILL
NOT UNLOCK
To check the oven gas shut off valve on sealed
burner
models,
remove
the storage
drawer, broiler drawer
or kick panel and look for the gas shut
off lever at the back of the range° On some models
you may have to
remove
an access cover also.
Sealed Burner Models
• Fluorescent
bulb is loose or defective.
Adjust
or replace.
= Switch
operating
light is broken.
Call for service.
o Oven:temperature
is too high to set self-cleaning
operation.
Allow the range to cool to room temperature
and reset the controls.
,, Door latch handle
not moved all the way to the right.
= The oven must cool below the locking temperature
after the clean cycle
is complete.
Do not lock
door with door
latch except
when using
the
self-clean
feature
or the oven may lock.
DOOR ACCIDENTALLY
• Press the CLEAR/OFF
pad. Allow the oven to cool. Unlatch
the door.
LOCKED
WHtLE
BAKING
OVEN NOT CLEAN
AFTER
CLEAN CYCLE
,door" APPEARS
IN THE DISPLAY
OVEN CONTROL
SIGNALS
AFTER ENTERING
COOK
TIME OR STOP TIME
• Oven controls
not set properly.
See the Operating
the Self-Cleaning
Oven section.
• Heavily
soiled
ovens require 3'½ to 4 hours of cleaning
time.
• Heavy spillovers
should be cleaned
up before starting
clean cycle.
,, Self-cleaning
cycle has been selected
butlatch
:handle was not moved
all the
way tothe
right. Move the latch handle.':
i
=Latch handle
was moved tothe
right buta
program
other than self-cleaning
was selected:
Move the latch handle tothe
right only when setting
self-
cleaning
cycle.
° This is reminding
youto
enter a bake temperature
(see the Baking section).
46