Titan Focus 500 Manual De Instrucciones página 21

Focus 500
5. Service
a) Have your tool repaired only by qualified specialist
personnel and only with original spare parts. This
ensures that the tool safety is maintained.
b) If the supply cord is damaged, it must be replaced
by the manufacturer or it's service agent or a
similarly qualified person in order to avoid a safety
hazard.
Safety instructions for colour application
devices
1. Risks of Fire and Explosion
When spraying flammable coatings vapours from
paint and solvents can cause flammable gases to be
produced in the work area (hazard area).
Risk of fire and explosion due to ignition sources in
this danger zone.
The electrically operated spray device contains
potential ignition sources (spark formation when
switching the motor on and off, when inserting and
removing the power plug, due to potential static
electricity at the spray gun)
-> Device must not be used at operating sites that fall
under the explosion protection ordinance.
-> Do not use combustible coating substances and
cleaning agents -> observe product data sheets!
->Always seal paint or solvent containers tightly in
the vicinity of the device.
-> When cleaning devices with flammable solvents,
disconnect the device from the mains and clean
thoroughly with a brush and cloth. Before starting
the device up again, ensure that all traces of solvents
are removed thoroughly. Allow the cleaned parts to
dry completely.
2. Warning: Danger of injury!
Never point spray gun at yourself, other persons or
animals.
3. When spraying paint wear a suitable respirator.
The user should be supplied with a breathing mask. In order
to avoid occupational diseases, the working instructions
provided by the manufacturer of the materials, solvents
and cleaning agents used must be complied with during
preparation, working with and cleaning the equipment.
Protective clothing, gloves and, if necessary, protective skin
cream is required to protect the skin.
4. Warning: When working with the paint spraying
system both indoors and outdoors, ensure that no
solvent-based vapours can form within the area of
the paint spraying system. When working in closed
places a sufficient ventilation must be ensured
to remove the solvent vapours.
5. Warning: The device is not splash proof. It should not
be used, neither outdoors in the rain nor be sprayed
with water nor immersed in liquid. Do not use the
device in damp or wet environments.
6. Attention! Never operate
the device if the nozzle seal
is missing, damaged or
incorrectly mounted. If the
nozzle seal is either missing,
damaged or incorrectly
mounted liquids can enter
the device and increase the
risk of an electric shock.
Check the nozzle seal before
each use.
7. The units may only be used with a functional valve. If
paints rises in the ventilating hose (Fig. 1, item 19) do
not operate the unit further! Dismantle and clean the
ventilating hose, valve and diaphragm and replace the
diaphragm if necessary.
8. Do not lay the filled spray gun down.
9. Extraction systems should be installed on-site according
to the local regulations.
10. The object to be coated must be earthed.
11. Caution against dangers that can arise from the sprayed
substance and observe the text and information on the
containers or the specifications given by the substance
manufacturer.
12. Do not spray any liquid of unknown hazard potential.
13. Before dismounting the spray attachment, relieve
pressure by opening the container.
14. Before working on the device, remove the power plug
from the socket.
15. Work or repairs on the electrical equipment should only
be carried out by a professional electrician, even if there
are instructions regarding such work in the operating
instructions. No liability will be accepted for improper
installation.
GB
SAFETY REGULATIONS
15